Friends of the West End Park

Historic West End*Atlanta*GA

FOLDING TOMATO CAGES June 4, 2009

208-018-01i1_resized400X266 Woody’s Folding Tomato Cages

Anyone can build these simple, sturdy tomato cages!

John “Woody” Woodzick

Link: http://www.motherearthnews.com/Organic-Gardening/2007-04-01/Do-it-Yourself-Tomato-

Cages.aspx

Materials List

Six 1-by-3-inch wooden strips measuring 8 feet long
A 2-by-4-inch piece of scrap board measuring 8 inches long, for the top section that will serve as the pivot point where the two “ladders” hinge
Two 3-inch deck screws
About 30 1/2 -inch galvanized deck screws

1. Cut two of the 8-foot 1-by-3s to make the pairs of rungs of your tomato “ladder.” Cut the first two rungs to 21½ inches long; the next two to 19½ inches; then 17½ inches. Also cut two 20-inch boards for the braces that will stabilize the sides of the ladder.

2. Next, lay out two of the 8-foot strips (for the legs of the ladders) on each side of the 8-inch 2-by-4 that is the top of the “ladder.” First, drill pilot holes into the legs, then connect the legs on each side with a 3-inch deck screw screwed into each end of the 2-by-4, creating the pivot point, so you can spread the legs out later.

3. Lay out the rungs, with the longest near the bottom.rilling pilot holes first, screw on the 21½-inch board at 7 inches from the bottom on the outside of the uprights, then repeat with the 19 ½-inch board at 12 inches from the first rung, then the 17½-inch board at 15 inches from the second rung (see Figure A). This will make the base of the stand wider than the top, allowing the structure to stand.

4. Turn the “ladder” over and screw on the other rungs at the same distance as the other uprights. The rungs will extend slightly on each end of the braces.

5. Stand the legs up and spread them out, then screw on the 20-inch 1-by-3 braces to each side of the “ladder” at 27 inches from bottom with one screw on each side (see Figure B).

6. You’re almost done. Now place the completed stand over a tomato plant and stake down two of its legs (opposite corners). I drive scrap 1-by-3s, pointed on one end, into the ground and then screw the legs to the stakes.

7. When you are ready to store the cages for winter, simply remove one screw from each side brace, as shown in Figure B.

Advertisements
 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s